Thursday, October 13, 2011

Micro MIll

I recently picked up this MicroMark mill. I got it off craigslist (Chicago) with a whole bunch of tooling. The cart / stand is from a hospital that also came from Craig's list.

The mill came with a DRO on the 3 axis's but the goofy rubber plugs that plug into the scales were so loose that the readout would not work half the time.

So, like  any other enthusiast I just cut them off and soldered the wires directly to the circuit board.

Once they were soldered  I assembled the units back together and I put some silicon in the pockets to seal them.

No comments:

Post a Comment